I am learning about inductors and capacitors and we derived the energy stored on a capacitor to be 50% of that delivered by the battery. We did this considering a circuit of a capacitor connected to a battery and resistor in series, to not encounter the problem of an infinite initial current if we assumed there was no other resistor in the circuit. However our lecturer assured us that no matter how small the resistance in the circuit (even if it is just the small resistance of the wires), exactly 50% of energy would be lost. This made sense to me from the mathematics. I assume that in the case of a capacitor it is impossible to consider the theoretical case with no initial circuit resistance as you get infinities popping up in the mathematics?
Then we considered an inductor charging in a simple circuit consisting of just a battery and an inductor, and found that all of the energy from the battery is stored on the inductor. I appreciate that this is just a theoretical treatment and that some energy would be lost in the wires/internal resistance of the battery, and I also understand why a similar theoretical treatment of the capacitor case is impossible; however I can't think of the fundamental reason as to why it is completely impossible to charge a capacitor with anything but 50% of the battery energy whereas an inductor could theoretically store 100%.
Answer
When you try to force current through a superconducting inductor, the change of current will generate a back emf that will limit how much current can flow. The value of this back e.m.f. is $-L\frac{dI}{dt}$, and the work done by the current is the product of the current and the back emf. If the back emf is exactly equal to the voltage of the battery, current can flow (and can keep increasing - the rate of change of current is $\frac{dI}{dt}=-\frac{V}{L}$ ). This shows the current will increase linearly as all the energy of the power source is converted to magnetic energy - there is no need for a "loss" of energy in the transfer of energy from a battery to an inductor.
By contrast, when you start charging a capacitor, its initial voltage is zero. Electrons that start off with the full potential of the battery will have to lose most of that energy on their way to the capacitor, where they will only have a very small initial potential (since V=Q/C, and Q starts out at 0).
So in the inductor, the energy is actually stored in the B field; in the capacitor, it is stored in the electrons that came from the battery.
If you could "ramp" your battery (make its voltage increase as the capacitor is charging) you would be able to get (close to) 100% of the energy of the battery transferred. There are certain switching power supplies that try to mimic this type of thing by rapidly opening and closing a switch between source and load, with an inductor in series to smooth some of the power fluctuations that this would otherwise bring about.
No comments:
Post a Comment